Info about the The next technique is adding fabric to the straps on a costume creating a braided or twisted effect. Braiding or twisting material around the straps of a costume is very simple. A couple of reasons for braiding or twisting fabric around the straps of a costume is to create a unique look and because it creates a little volume and texture around the face which gives the top a nice soft look up by the face.

Supplies:

Dance top with straps
Fabric for braided material
Thread to match fabric
Measuring tape
Scissors
Safety pins
Straight pins

Directions:

Choosing the Material

You need to make sure the fabric you use is stretchy or you will create a problem when the dancer goes to move while wearing the costume. You can make the strips of the same material as the top, a different material, lace or a combination of materials. This method is often done in different materials or different colors at the same time. You need to think about the look you want before you purchase your material.

Braiding or twisting material around the straps of a costume is very simple. A couple of reasons for braiding or twisting fabric around the straps of a costume is to create a unique look and because it creates extra fabric and texture around the face giving the top a softer look.

Placing and Pinning the Material

You need to think about where you want to start placing the material. Often rhinestones are put on that starting point and it comes out really pretty. Using two strips of fabric, tuck the first strip a couple of inches below the shoulder under the strap on the neck side. Tuck the second strip under the strap but about an inch higher than the first and on the armhole side of the strap. At this point, roll each strip a little and then start braiding the strips around the strap until you reach the neckline on the back of the top and pin the back of the strips down. For an alternate look, shift that starting point at the neckline on the front and continue braiding to the back neckline.

Sewing the Material

At that point, sew the ends in the front of the top securely underneath making sure that the stitches and ends of the strips are hidden. Then go to the back and tie the strips in a knot around the strap and let them hang loose. To finish it off, you should cut the ends of the strips at an angle. An alternate choice would be to tuck the ends inside the top at the back neckline so it looks like it does in the front, sew the ends down and cut the ends off. Make sure the stitches do not show on the outside. Finally, to make sure the braiding does not move around, it is best to tack the braiding down all along the strap.

Adding Fabric or Lace to Dance Tops

The fifth method to enhance a dance costume is to add lace appliqués to a dance top. A sports bra is used in this example. You can use this technique on other tops and you can be creative with the placement of the appliqué. One reason you might want to do this is it gives the costume a very unique and a very expensive look and it is very simple to do. Additionally, it draws the look up to your face.